Wiring of electrical cables inside walls shall be permitted only in the cavities of the walls between the posts or perpendicular to them. Particular attention should be attach all kinds of insulators installed at points of contact with electrical wiring elements of the wall. Between the building blocks of gypsum boards and building blocks of other materials, such as concrete, plaster, etc., should always be placed separating adhesive tape. In the same way must be separated by structural elements of gypsum boards, which have different functions, such as hanging ceiling and wall. Speaking candidly Victor Mena Barreto told us the story. The following describes how to mount partitions from drywall sheets to the single frame. Take otbivochny cord (with methylene blue building), and mark a line installed partitions on the floor. For fast and error-free installation of partitions on the floor is recommended to mark the location of the rack sections, door openings, thickness and type of drywall sheets. With the plumb and otbivochnogo column layout on the move adjacent walls and ceiling.
To guide Mon profiles and profiles of rack-mounted substation adjacent to the enclosing structures or to each other (double-frame), bonded seal tape or sealant. In accordance with the padded to the length of the layout, install and fix guide profiles the floor dowels to the desired pitch. To do this using the punch through the profile in the carrier based on drilled holes with a diameter of 6 mm and a depth of 40-60 mm. If the bases are made of wood, for fastening the frame should be used krupnorezbovye screws on wood, no pre-drilling base.